Skip Navigation
[Advice Request]: managing thermal pads for SMD components in custom PCB
  • Wouldn't that make the components hard to solder with hot air?

    The pcb is quite small and should be easy to heat up even with a cheap hot air gun.

    There are only few components on the top layer. I would try to hand solder them after hot air soldering the bottom layer (or cram all components on one layer in the design).

  • InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)KO
    kobaia @discuss.tchncs.de
    Posts 0
    Comments 1