That looks like a clog.

Try heating up the end, then removing the filament, then cut the filament flush and push it into the end, lower the temp a bit, and yank it out. Do that a few times to try and clear the clog. You can also heat the end, remove the nozzle, and clean it.

While it's off, try pushing through some fresh filament by hand.

You were printing with wood, so it probably has wood particles stuck in it.

I get different results with each eye 🤔

This must be the current default behavior if you have personalization disabled. I've had it off forever and mine does this too.

They generally have quite a few other things in them that could make you feel sick. Like a ton of b vitamins and various herbs. It could also be you react badly to the sweeteners in it.

Homeless does not necessarily mean jobless. You still have to file taxes if you want a tax return. It's a lot cheaper to live out of a car and have a PO box than it is to get an apartment.

As a gay furry, it's true I would do a lot for head scritches and treats, but I'll happily give hugs regardless ♥️

Bilbo Bagger

How's the input sanitisation?

,./;'[]-= <>?:"{}|_+ !@#$%^&*()~ Ω≈ç√∫˜µ≤≥÷ åß∂ƒ©˙∆˚¬…æ œ∑´®†¥¨ˆøπ“‘ ¡™£¢∞§¶•ªº–≠ ¸˛Ç◊ı˜Â¯˘¿ ÅÍÎÏ˝ÓÔÒÚÆ☃ Œ„´‰ˇÁ¨ˆØ∏”’ ⁄€‹›fifl‡°·‚—±

And gotta have emoji support :p

ヽ༼ຈل͜ຈ༽ﾉ ヽ༼ຈل͜ຈ༽ﾉ (｡◕ ∀ ◕｡) ｀ｨ(´∀｀∩ __ﾛ(,,) ・(￣∀￣)・:: ﾟ･✿ヾ╲(｡◕‿◕｡)╱✿･ﾟ ,。・::・゜’( ☻ ω ☻ )。・::・゜’ (╯°□°）╯︵ ┻━┻) (ﾉಥ益ಥ）ﾉ ┻━┻ ┬─┬ノ( º _ ºノ) ( ͡° ͜ʖ ͡°) ¯_(ツ)/¯