It's a strawman because they're trying to shift the focus from one thing (the system is broken) to another (Republicans are bad)

That's a strawman argument. Pointing out that one of them is worse than the other ignores the real problem - the system is broken.

I'm not a CPA, but I don't think you can write off something that already made a profit. How would that even work, if companies were able to write off predicted ad revenue? They could make up any value and never have to pay any taxes at all.

I don't think write-offs have anything to do with them removing these episodes.

I don't think they can write it off either way, though. It only makes sense to write off shows that haven't made money. It's just "retiring" when you're taking about something that's already been released. There's no ulterior profit motive, unlike when they write off unreleased movies and shows.

What does this have to do with write-offs? I don't think they can write off episodes of South Park and the daily show that have already aired.

That depends on your OPSEC.

Isn't the same true in the EU, then?

You also don't need to show any ID for a business to meet "know-your-customer" regulations. Can you get a phone number without revealing your identity?

To be fair, "merging with" doesn't specify which one will be managing the other. Unlike "merging into"...

I believe the same is true in the US.

They're targeting people selling stolen credit cards and drugs, who are advertising on telegram. Your friend (SWIM?) is fine.

I tried printing a disk with the bed at 70c and it looks better. Going to try with it even higher. This sheet has a +0.350 z offset compared to my normal PEI sheet, so that might contribute to low heat conduction.

It was out of mind until I got this new build plate with a fancy texture that I want to imprint on my prints.

This is PLA, I can't get PETG to stick to the "PEO" bed plate.

I thought genies were bitter because they're trapped in a lamp and forced to grant wishes?

Thanks, now I'm hungry

I tried adjusting the z offset to raise the nozzle, but it didn't help.

My bl-touch mount broke so I've been doing manual bed leveling for a while. I just finished printing a 185x185mm part (half of a dactyl keyboard) and the first layer looked great from the top.

Edit: I also deleted the old bed mesh from my klipper config when the bl-touch broke

40/200 looks the same as 60/220. I can try 60/210 but I don't think it will be any different.

It's hot - 60 bed, 220 nozzle. I'll try 40/200