Anker eufyMake E1 3D-texture UV printer now crowdfunding

I watched a youtuber that was using this, and the cost to print something was pretty high. Like a 2 inch by 2 inch tile with a little depth was like $2 USD for the ink/resin alone. A larger board that looked like it was about 1 ft by 2 ft, with a single layer of print (no depth), was about $25, IIRC.

It's beautiful, but so expensive to run, IMO.

Heads up, I asked their support and it works neither on Linux nor without cloud.

Cool device though.

🤞🏼🤷🏼‍♂️