Skip Navigation

3DPrinting @lemmy.world

TerraRoot @sh.itjust.works

3w ago

Sovol sv08

Finally got it out of the box, setup, explore the new features, amazed at those, and the extreme exhaust fan noise.

So what do I do with this monster that I couldn't do with my ender 3? yup bag clips.

6 comments

I replaced the idiotically loud motherboard fan with a 24V 40/10 Noctua. It needs slightly longer screws than the stock ones but otherwise it's a drop in replacement. Noise levels are much more acceptable now.
- I've been doing some light research and i think it's possible to run the stock fan slower and turn it off when not printing, but it's unclear whether i'd have to plug the fan into a different header or not.
  Because the full info is in a private facebook group :bleugh:
  
  Is it running Klipper or something else?
  In Klipper I have my controller board fan set to speed up only when there’s any active heaters or stepper drivers?
  E.g. fires up only when moving/heating or printing but not when idle. Even then it’s set to a reasonable 80% threshold.

6 comments