Anyone have experience with the Jonsbo N1? Thinking of modding one

So it's a SFF case meant for NAS use. It has 5 slide-in 3.5" drive bays and can only handle a low-profile PCIE card.

I'm thinking of picking one up and mangling it to force in a 2-slot GPU. I want to basically remove the drive bays and the PCB with the SATA slots, ditch the PSU frame, move the motherboard frame back or flip it around, and 3d print a new backplate for the case.

I'd stick the PSU where the drive bay used to be and run an extension to the back of the case, and then there should be room for a full-sized GPU mounted vertically in the case.

Do you think this would be achievable? Am I crazy for even thinking about it?

Now if only I could also fit an AIO in there.

EDIT: Link to the case - https://www.jonsbo.com/en/products/N1.html