Print failed successfully!
Print failed successfully!
Turned on retraction speed to 11 and i guess it wore down the filament at one part but then managed to push it after some 10 minutes of spaghetti 👌
You're viewing a single thread.
42
comments
How is that even possible that’s awesome.
Cooling fan cooled the spaghetti, and when enough got formed, outer perimeters started building the Z support. After some time, the infill actually caught to the flying spaghetti and created a “solid” bottom layer upon other layers managed to stick. Due to the flexible nature of spaghetti structure, the printed part was wobbling quite much and couldn’t retain the dimensional accuracy 😕
You've viewed 42 comments.